An All-Inclusive Guide to Fix Not Working Issue not working is one of the most common issues that users face whenever they try to log in to their Netgear range extenders. If you are standing in the line, then consider following the troubleshooting hacks mentioned in this post. They will be of some assistance to you in fixing the issue and help you log in to your wireless device without any hassle. Continue reading.

How to Fix Not Working Issue?

  1. Use the Correct Web Address

One of the biggest reasons why you are struggling with the not working issue is because of an incorrect web address.

Therefore, the next time you try to log in to your Netgear WiFi range extender, make sure that you type the correct web address in the address bar of your web browser. Also, cross check the default web address before hitting Enter.

Note: You can also use the default IP address to log in to your wireless device.

  1. Check Your Ethernet Connection

If the Ethernet cable connecting your Netgear range extender and the existing router is damaged, then also you can come across the not working issue.

Thus, make sure that the Ethernet cable connecting your devices is free of damages. If you want to skip taking this responsibility, consider connecting your devices using a wireless source.

Now, connect your WiFi-enabled device to Netgear_ext SSID and check if you are able to access No? Well, in that case, keep reading.

  1. Contact Your ISP

There is a high possibility that your Internet Service Provider is not doing his job properly. To confirm the same, get in touch with him.

If your ISP agrees that there is an internet issue from his end, give him a couple of hours to get the issue resolved.

  1. Update Your Internet Browser

Maybe the internet browser you are using to access is not running on an updated version. So, what to do? Well, the answer is to simply update your browser.

In order to do so, go to the Settings menu of your internet browser, look for any available updates, and click Upgrade. Also, clear the cache, cookies, and browsing history of your browser to avoid facing any other technical issue.

  1. Disable Antivirus Software

Yes, we are aware that antivirus software is important to keep a device safe from potential threats. But, what you don’t know is that such software can prevent you from accessing certain websites, including

To troubleshoot the issue, it is recommended that you temporarily disable the antivirus software on your WiFi-enabled device.

Did none of the aforementioned troubleshooting tips help you get rid of the not working issue? If you are nodding your head in yes, perform factory default reset.

How to Reset Netgear WiFi Range Extender?

Follow the below-mentioned instructions and learn how to reset your Netgear wireless range extender:

  • Look for the Reset button located on your WiFi device.
  • Take an oil pin, a paper clip or toothpick, and carefully press it in the Reset hole.
  • Wait for a couple of seconds.

In some time, your Netgear range extender will get restored to the factory default settings.

Note: After resetting your wireless device, perform new extender setup. You can use three methods to reconfigure your Netgear extender. They are as follows:

  • Via Manual method
  • Using Nighthawk app
  • By pressing the WPS button

Sum Up

Troubleshooting the not working issue is not that difficult. However, many users face issues while doing so. If you are one of those users, taking the help of the troubleshooting steps mentioned above will be the best decision you will ever make.

If this article helped you in fixing the not working issue, do let your fellow readers know by dropping a word in the comment section.